Performance Optimized Down Fire Wide Sealed 12" Shallow Sub Enclosure Wavtech thinPRO12 · Single 12" Sealed enclosure

Because it trades length for depth and height. The standard single Down Fire platform is 30 wide by 15 deep; this one is 14 deep, 1 inch shallower, and runs 41 inches long to put the airspace along the length instead.

That lets it stand 4.625 inches tall against 5.25 for the standard box. A 12 inch frame needs about 13 inches of baffle, so 14 is as shallow as a 12 can go. If you have 41 inches of run and height or depth is your limit, this is the shape that works.

The standard box is 30 by 15 by 5.25 inches and holds 0.60 cubic feet net. This one is 41 by 14 by 4.625 inches and holds 0.613 cubic feet net.

Choose the standard box when length is limited. Choose this one when height or depth is the limit and you have 41 inches of run.

At 0.613 cubic feet net the result is thinPRO12-2: Qtc 0.906, Fc 46.2 Hz, F3 38.2 Hz; thinPRO12-4: Qtc 0.851, Fc 48.1 Hz, F3 41.3 Hz, calculated from the driver's own published Thiele-Small parameters.

That is above the 0.707 maximally flat reference, so there is real lift near the corner rather than a textbook flat curve. The figures are anechoic; in a car, cabin gain adds real output below 50 Hz, so in-vehicle response runs deeper.

Wāvtech rates the thinPRO12 at 750 watts RMS and 2250 peak, and recommends 250 to 750 watts. Aim for the upper half, since sensitivity is 83 dB on the -2 and 84 dB on the -4.

Both are single voice coil, so impedance is fixed by the model: 2 ohms for the -2, 4 ohms for the -4. Confirm the load against your amplifier's minimum stable impedance.

The cabinet is 4.625 inches tall measured in the down fire position, excluding standoffs. The standoffs hold 1.75 inches under the baffle, so plan your space around 6.375 inches installed.

The standoffs ship uninstalled, so you can place them to suit your floor, or leave them off and run the cabinet front firing or up firing.

Side mounted. Every Proline X Performance Optimized enclosure uses a side mounted terminal cup regardless of alignment, whether standard, wedge, or down fire. On this cabinet that keeps the connection accessible with the enclosure installed, since the baffle faces the floor. The cup is our Proline X ABS and carbon fiber composite unit with stainless hardware, copper ring terminals, and pre-wired 12 gauge OFC.

V-groove and dado joinery, CNC cut on ShopSabre routers from Langboard Elite MDF, with square corners as the Down Fire standard. Every panel joint is a machined interlocking groove that locks before adhesive is applied, which keeps the cabinet airtight under sustained pressure cycling.

The 1.5 inch double baffle has its outer layer machined as a flush recess so the driver bolts to the inner layer, and a windowed U-brace stiffens the long panels. Polyfill is installed as a light wall lining; do not add more, since packing a sealed box makes it act larger and moves the alignment. Assembled and inspected in Tullahoma, Tennessee.

No. This listing is for the enclosure only. Bring your own Wāvtech thinPRO12-2 or thinPRO12-4. The cutout and cabinet height are cut direct fit for this driver.