Dayton Audio Reference RSS210HF Dual Box: Ported 8" Professional Series Enclosure Dual 8" Ported enclosure

Both drivers share one chamber and one port rather than sitting in separate boxes, so the pair works against the whole volume and the port is sized for the pair rather than doubled. The port carries 15.6 square inches of area at 36.0 Hz, and the design power for the velocity and excursion checks is 672 W for the pair. Passband ripple holds at 2.35 dB across the tuning, with F3 at 40.5 Hz. Tuning is chosen for in-car response rather than an anechoic curve: a vehicle adds roughly 12 dB per octave below about 45 Hz, and this tuning is where that sum comes out flattest across 25 to 60 Hz.

A single Reference RSS210HF also builds in the Performance Optimized ported wedge, the smaller and cheaper single-driver box. A pair takes this Professional cabinet: one shared chamber on a 2.25 inch three-layer baffle with both woofers flush in the outer layer, and a slot port gated at 672 W for the pair. It carries a 2 year warranty, against 1 year on the Performance Optimized lines.

Threaded inserts pressed into the baffle on the published 7.756 inch bolt circle, stainless machine screws included. The inserts are in the baffle when it arrives; the machine screws are in the terminal cup bag.

Yes, at 28 Hz, 24 dB per octave. Below tuning a vented box stops loading the cone and excursion runs away toward DC. With the filter in place this cabinet puts the Dayton Audio Reference RSS210HF at 89 percent of its usable travel at 672 W.

Not one we can show you. We do not build a sealed enclosure for the Dayton Audio Reference RSS210HF and Dayton Audio publish no sealed volume for it, so the Performance Graphs tab carries no ported-versus-sealed chart: the only sealed box left to plot would be this cabinet stuffed and sealed, which nobody would build, and a comparison against it would tell you nothing you could buy. What a vented box gives up is the region below tuning, where the cone unloads and the 28 Hz subsonic filter takes over; around 36.0 Hz the vent carries the load and cone travel drops to its minimum, which no sealed alignment can do.

It is a vertical slot beside the woofer, the full height of the cavity, 1.25 inches wide and 15.6 square inches. It runs 4.00 inches to the back wall and turns once along it for 21.78 inches; the fold costs about 1.5 Hz and the port is cut for it. The channel runs at 17.7 metres per second at 672 W, 47 percent of its turbulence limit, and the mouth edges carry a 1/2 inch roundover so the air leaves the face at 9.1 metres per second against the 17 metres per second threshold where a slot starts to chuff.

46 lb, 34.00" W x 14.00" H x 9.00" D external. This cabinet is 2.48 cubic feet outside. Delivery to the 48 states is inside the price; it ships as a 46 lb parcel and checkout adds nothing. Do not add polyfill; it ships dry on purpose.

No. This is an enclosure only, cut for the Dayton Audio Reference RSS210HF specifically: the 7.283 inch cutout, the 4.882 inch mounting depth allowance and the 0.86 cubic foot alignment all come from Dayton Audio's published parameters. Dayton make the RSS210HF in one version, single 4 ohm (RSS210HF-4). Bring your own driver.