Professional Series Ported 10" Enclosure NVX VSW10v3 · Single 10" Ported enclosure

Sealed, the VSW10v3 needs 0.17 cubic feet net to reach a Qtc of 0.707. Vented, it trades that for deeper extension. The slot is gated at 720 W, 1.2 times NVX's rating: the channel runs 23.5 m/s and the mouth 13.9, and the cone peaks at 8.2 of its 13.5 mm with the subsonic filter in place. Tuning is chosen for in-car response rather than an anechoic curve: a vehicle adds roughly 12 dB per octave below about 45 Hz, and this tuning is where that sum comes out flattest across 25 to 60 Hz.

The VSW10v3 also builds in the Performance Optimized ported down-fire, the smaller and cheaper box. The Professional cabinet is the step up for it: a 2.25 inch three-layer baffle with the woofer flush in the outer layer, and a slot port gated at 720 W. It carries a 2 year warranty, against 1 year on the Performance Optimized lines.

Threaded inserts pressed into the baffle on the published 9.680 inch bolt circle, stainless machine screws included. The inserts are in the baffle when it arrives; the machine screws are in the terminal cup bag.

Yes, at 28 Hz, 24 dB per octave. Below tuning a vented box stops loading the cone and excursion runs away toward DC. With the filter in place this cabinet puts the NVX VSW10v3 at 61 percent of its usable travel at 720 W.

Not one we can show you. We do not build a sealed enclosure for the NVX VSW10v3 and NVX publish no sealed volume for it, so the Performance Graphs tab carries no ported-versus-sealed chart: the only sealed box left to plot would be this cabinet stuffed and sealed, which nobody would build, and a comparison against it would tell you nothing you could buy. What a vented box gives up is the region below tuning, where the cone unloads and the 28 Hz subsonic filter takes over; around 36.0 Hz the vent carries the load and cone travel drops to its minimum, which no sealed alignment can do.

It is a vertical slot beside the woofer, the full height of the cavity, 1.75 inches wide and 21.9 square inches. It runs 6.38 inches to the back wall and turns once along it for 18.56 inches; the fold costs about 1.5 Hz and the port is cut for it. The channel runs at 23.5 metres per second at 720 W, 54 percent of its turbulence limit, and the mouth edges carry a 1/2 inch roundover so the air leaves the face at 13.9 metres per second against the 17 metres per second threshold where a slot starts to chuff.

47 lb, 30.00" W x 14.00" H x 11.88" D external. Every Professional cabinet is priced the same way, by its size: this one is 2.89 cubic feet outside. Delivery to the 48 states is inside the price; it ships as a 47 lb parcel and checkout adds nothing. Do not add polyfill; it ships dry on purpose.

No. This is an enclosure only, cut for the NVX VSW10v3 specifically: the 9.010 inch cutout, the 5.800 inch mounting depth allowance and the 1.19 cubic foot alignment all come from NVX's published parameters. It fits both coil versions (D2 and D4), and the cabinet was checked against both. Bring your own driver.